My club Evolution Jeep Alliance took a trip out to Colorado for two weeks of wheeling. This jack I had purchased at the All Breeds Jeep Show just for this trip. It ended up being the best investment I made. It was used to rebuild 3 axle shafts, diagnose a bad wheel sensor and rebuild two trailer wheel bearings. With onboard air and power tanks we lifted everything easily.
Advantage ML-2000 Motorcycle Single-Post Lift
Our multi-lift single-post lift is a great lift for picking up ATVs, UTVs, lawn mowers (zero turns), golf carts, and just about any small utility vehicle. The single-post take up less room in your garage and runs on a 110V power unit. The ML-2000 comes with three piece removable center aluminum deck inserts (54" W x 21" D) and six drive-on aluminum ramps.
This lift needs to be anchored to the floor. 4" of concrete with a 3,500 lb mix required. The overall foot print is 9' 4" high, 8' 7" wide, 7' deep, and has a maximum lifting height of 72" and maximum lifting capacity of 2,000 lbs. The runways extend out to 8' 4" wide and are 5' deep.
Ceiling Height Requirements: 9'6" Minimum
What This Lift Includes:
- 110 Volt Power Unit
- Great lift for small utility vehicle
- Includes 6 drive-on ramps
- With 3 removable aluminum deck insert
Shipping/Receiving Your Lift
Shipping cost is based on the individual model. Costs are based on your
location. Ex. We do not ship to Hawaii, Puerto Rico, US military
installations or internationally.
There are multiple options for the delivery of your Advantage Lift.
Option 1: Pick up from one of our warehousing facilities. The available locations are:
-Inver Grove Heights, MN
-Park City, KS
Option 2: Have the lift shipped to a nearby truck terminal or commercial
address. In some markets residential delivery only is an option. Reach
out for more details on delivery only options.
Option 3: Have your lift delivered and installed at your location. If
your lift will be installed by Advantage Lifts or an installer within
our network, the customer service team will coordinate deliver with the
installer. There is no additional action needed on your part.
No. Removing the lift from the height of a tractor trailer without benefit of a receiving dock and forklift is unsafe.
We only ship to commercial
addresses with a receiving dock, and a forklift, or to a trucking terminal.
We recommend a 16’ + open car trailer for picking up a 4-post Advantage Lift.
We recommend a 12’ + open car trailer for a 2-post lift.
You can not load a lift into the bed of a pickup truck.
Yes, we have a network of installers nationwide. Call us for more installation
information, or a quote 763-300-5730.
Prices will vary based on quantity, and location. Plan on an average installation cost of $1200 per lift.
Yes, installation can be done by 1 individual, although we recommend using a lifting
device for the runways, and overall assembly usually works best with 2-3 people. The
installation is not complicated. The cables come pre-strung and the locking mechanism
is pre-assembled. The total number of parts requiring assembly are minimal.
We have heard from customers after they installed their lift that it was much easier than
expected! Be sure to view our installation videos
Advantage Lifts Installation Videos
We recommend you do not anchor Advantage 4-post lifts. Challenger 4P14 should be
4” concrete is the recommended thickness.